BendPak Clearfloor 10AP - Page 67

10AP Series Two-Post Lifts 67 P/N 5900265 — Rev. A6 — December 2022
To raise the Lift:
1. Press and hold Up Button.
2. When Lift is just past
desired height, release Up
Button.
3. Press and hold Lowering
Handle.
Do not pull down the Safety
Lock Release Handle. If you
do, the Lift will continue to
lower and will not engage
on its Safety Locks.
Lift engages on its Safety
Locks and stops moving;
release Lowering Handle
when Lift stops.
Only leave Lift on Safety
Locks or fully lowered.
To lower the Lift:
1. Press and hold Up Button
for two to three seconds.
This moves Lift off its
Safety Locks.
2. Pull down and hold Safety
Lock Release Handle
and
Lowering Handle.
Lift begins lowering.
3. When Lift is fully lowered,
release Safety Lock
Release Handle and
Lowering Handle.
Only leave Lift on Safety
Locks or fully lowered.
Lowering a Vehicle
To lower a Vehicle off the Lift, first raise it a small amount to get it off its Safety Locks, then lower it.
To lower a Vehicle off the Lift:
Check under and around the Vehicle to make sure the area is clear of all obstructions.
If you find any obstructions,
move them out of the way .
Press and hold the Up Button for a second or two to move the Lift off its Safety Locks.
Raise the Lift at least two inches to get clear of the Safety Locks.
Pull down and hold the Safety Lock Release Handle (on the Powerside Post above and to the right
of the Power Unit).
Push and hold the Lowering Handle (on the front of the Power Unit). The Lift begins lowering.
NOTICE Both the Safety Lock Release Handle
and the Lowering Handle must be held down
at the same time to lower the Lift.
⚠ WARNING Do not override the Lift controls. For safety purposes, Lift controls are designed to
stop the Lift if released. Overriding the Lift controls could lead to damage to the Lift,
damage to the Vehicle on the Lift, injury, or in rare cases, death to persons near the
Lift.
⚠CAUTION Remain clear of the Lift as it comes down; obey the pinch point warning decals.
When the Lift is on the ground, release both Handles, then move all four Lift Arms to their full drive-
through positions.
Carefully drive the Vehicle out.