10AP Series Two-Post Lifts 66 P/N 5900265 — Rev. A6 — December 2022
⚠ DANGER Do not raise the Lift further until you are certain the Vehicle on the Lift is both stable
and balanced. If the Vehicle is
not
stable and balanced, it could fall, which could
damage the Vehicle, damage the Lift, as well as injure or kill anyone under the
Vehicle.
⚠ WARNING Always keep a line of sight on the Lift. Ensure personnel and objects are always
clear of the Lift.
⚠ WARNING Remain Clear of the elevated Lift until visual confirmation is made that all Safety
Locks are fully engaged, and the Lift is lowered onto the Safety Locks.
Press and hold the Up Button.
Listen as the Lift passes the Safety Locks; you should hear a thump as each side passes by the
Safety Locks at approximately the same time.
When the Vehicle reaches the desired height, go past the next Safety Lock position (you will hear
the thump as it passes), then release the Up Button.
Press and hold the Lowering Handle, which lowers the Lift onto the Safety Lock position you just
passed. Do
not
hold the Safety Lock Release Handle, which is for lowering the Lift to the ground.
When the Lift stops moving down, it is engaged on its Safety Locks; release the Lowering Handle.
Do not leave the Lift controls unless the Lift is engaged on its Safety Locks or
fully lowered.
Recheck the Adapters to make sure they are all still making solid contact with the Lifting Points.
Verify the Lift is engaged on the
same Safety Lock
on both Posts.
⚠ DANGER Always ensure both Safety Locks are engaged. If the Lift Heads are engaged on
Safety Locks at two different heights or only one Safety Lock is engaged, the
Vehicle could become unbalanced and fall causing damage, injury, or death.
Begin work on the Vehicle.
To Next Page
