GrandPrix (GP-7 Series) Two-Post Lifts 12 P/N 5900209 — August 2018 — Rev. C2
Installation Checklist
Following are the steps needed to install a GP-7 Series lift; perform them in this order.
☐ 1. Review the installation safety rules.
☐ 2. Plan for electrical work.
☐ 3. Make sure you have the necessary tools.
☐ 4. Select the installation location.
☐ 5. Check the Clearances.
☐ 6. Unload and unpack the components.
☐ 7. Review the installation orientation.
☐ 8. Put down Chalk Line Guides for the posts.
☐ 9. Install the Post Straps.
☐ 10. Install the Powerside and Offside Posts.
☐ 11. Route the Lifting Cables.
☐ 12. Prepare the Top Trough.
☐ 13. Install the Top Trough.
☐ 14. Install the Power Unit (but don’t connect it to power yet).
☐ 15. Install the Safety Assemblies and the Safety Cable.
☐ 16. Install the Trip Stop Tube.
☐ 17. Install the Microswitch and the Microswitch Cable.
☐ 18. Install the Hydraulic Lines.
☐ 19. Connect the Lifting Cables.
☐ 20. Install the Safety Covers.
☐ 21. Install the Lift Arms.
☐ 22. Perform final leveling of the posts.
☐ 23. Connect the Power Unit.
☐ 24. Install the Power Disconnect Switch.
☐ 25. Install the Thermal Disconnect Switch.
☐ 26. Lubricate the lift.
☐ 27. Bleed the Hydraulic Cylinder.
☐ 28. Review the final checklist.
To Next Page
Loading...
