GrandPrix (GP-7 Series) Two-Post Lifts 50 P/N 5900209 — August 2018 — Rev. C2
Maintenance
⚠ DANGER Before performing any maintenance on your lift, make sure it is completely
disconnected from power.
To maintain your lift:
• Daily: Keep the lift clean. Wipe up any spills, clean any dirt.
• Daily: Make a visual inspection of all moving parts and check for damage or excessive wear.
Replace any damaged or worn parts before using the lift.
⚠ DANGER Do not use the lift if the cables are damaged or extremely worn. If a vehicle is raised
when you notice the damage or extreme wear, very carefully lower the vehicle to
the ground. When the lift is on the ground, remove it from service, disconnect it
from power, and make arrangements to get it fixed.
• Daily: Make sure Safety Locks are in good operating condition. Do not use your lift if the Safety
Locks are damaged or excessively worn.
• Weekly: Check all controls to make sure they are functioning normally.
• Weekly: Check all labels on the lift. Replace them if they are illegible or missing.
• Monthly: Lubricate the posts. We recommend using white lithium grease or similar.
• Monthly: Check Power Unit hydraulic fluid levels. Refill if low.
• Monthly: Check cable connections, bolts, and pins for proper mounting and torque.
• Monthly: Check arm adjusting locks for proper operation.
• Monthly: Make sure all pivot arm pins are properly secure.
• Every two months: Check all Anchor Bolts to make sure they are correctly torqued. If they are
not, torque them.
• Every three to five years or as needed. Carefully check the lifting cables every three to five
years, or immediately if there are signs of damage or extreme wear.
⚠ WARNING: Do not operate your lift if you find maintenance issues; instead, remove it from
service, then contact your dealer, visit bendpak.com/support, email
techsupport@bendpak.com, or call (800) 253-2363.
To Next Page
Loading...
