GrandPrix (GP-7 Series) Two-Post Lifts 13 P/N 5900209 — August 2018 — Rev. C2
Installation
The installation process includes multiple steps. Perform them in the order listed.
Safety Rules
When installing the lift, your safety depends on proper training and thoughtful operation.
⚠ WARNING Do not install this equipment unless you have automotive lift installation training.
Always use proper lifting tools, such as a forklift or crane, to lift heavy components.
Do not install this equipment without reading and understanding this manual and
the safety labels on the unit.
Only fully trained personnel should be involved in installing this equipment. Pay attention at all times.
Use appropriate tools and lifting equipment, when needed. Stay clear of moving parts.
⚠ WARNING You must wear appropriate protective equipment: leather gloves, steel-toed work
boots, eye protection, back belts, and hearing protection.
Electrical Work
You will need to have a licensed, certified electrician available at some point during the installation.
⚠ DANGER All wiring
must
be performed by a licensed, certified electrician.
The electrician needs to:
• Connect the 220 VAC power source to the Power Unit. This is generally done near the
end of the installation process; do not connect the Power Unit at the same time as you install it.
• Install a Power Disconnect Switch. A Power Disconnect Switch ensures that the equipment
shuts down in the event of an electrical circuit fault or emergency situation. Refer to Install a
Power Disconnect Switch for more information.
• Install a Thermal Disconnect Switch. A Thermal Disconnect Switch ensures that the
equipment shuts down in the event of an overload or an overheated motor. Refer to Install a
Thermal Disconnect Switch for more information.
Tools
You may need some or all of the following tools:
• Rotary hammer drill (or similar)
• ¾ inch carbide bit (conforming to ANSI B212.15-1994)
• Hammer
• Four-foot level
• Open-end wrench set, SAE and metric
• Socket and ratchet set, SAE and metric
• Hex key wrench set
• Crescent and pipe wrenches
To Next Page
Loading...
