HD-973P Series Multi-Level Parking Lift 15 P/N 5900076 — Rev. B3 — January 2024
Installation
The installation process requires multiple steps. Perform them in the order listed. Read the entire
Installation section before beginning the install; this gives you a better understanding of the
process as a whole.
⚠ WARNING Only use the factory-supplied parts that came with your Lift. If you use
parts from a different source, you void your warranty and compromise the safety of
everyone who installs or uses the Lift. If you are missing parts, visit
bendpak.com/support or call (800) 253-2363, option 7 then 5.
Safety Rules
While installing this equipment, your safety depends on proper training and thoughtful operation.
⚠ WARNING Do not install this equipment unless you have automotive Lift installation training.
Always use proper lifting tools, such as a Forklift or Shop Crane, to move heavy
components. Do not install this equipment without reading and understanding this
manual and the safety labels on the unit.
Only fully trained personnel should be involved in installing this equipment. Always pay attention. Use
appropriate tools and lifting equipment. Stay clear of moving parts.
BendPak recommends referring to the ANSI/ALI ALIS Standard (current edition) Safety Requirements
for Installation and Service for more information about safely installing, using, and servicing your Lift.
⚠ WARNING You must always wear OSHA-approved (publication 3151) personal protective
equipment when installing, using, maintaining, or repairing the Lift: leather gloves,
steel-toed work boots, eye protection, back belts, and hearing protection are
mandatory.
You may need some or all the following tools and supplies:
• Rotary hammer drill or similar
• ¾ inch masonry bit (ANSI B212.15)
• Hammer and crowbar
• Two 2 x 4 pieces of Wood (≤52 in.)
• Zip ties
• Four-foot level
• Open-end wrench set, SAE, and metric
• 12-foot ladder
• Hex key wrench set
• Medium adjustable wrench, torque wrench, pipe
wrench
• Chalk line
• Medium-sized flat screwdriver and needle-nose
pliers
• Tape measure (25 feet or above)
• Forklift, Shop Crane, or heavy-duty rolling dolly,
Lifting Straps, and two sawhorses
• Socket and ratchet set, SAE, and metric
• Red and white lithium grease
To Next Page
Loading...
