MD-6XP Mid-Rise Scissor Lift 26 P/N 5900108 — Rev. F — March 2020
About Safety Locks
Your Lift comes with three Safety Lock positions; they serve two important functions:
• Safety. Safety Locks hold the Platform in place. Once the Lift is engaged on the desired Safety
Lock, the weight of the Vehicle holds the Platform in place. If the power goes out, the Safety Lock
holds the Platform, and anything on it, in place.
⚠ WARNING Always leave your Lift engaged on a Safety Lock or fully lowered. Although rare, it is
possible for Hydraulic Fluid in the Hydraulic Cylinders to leak, causing the Platform
to slowly come down if it is not engaged on a Safety Lock.
Always leave the
Lift either fully lowered or engaged on a Safety Lock.
• Adjustable height. Having multiple Safety Locks means you can raise the Vehicle to just the
right height for the work you are performing.
To put your Lift on a Safety Lock:
1. Press the Up button on the Power Unit to raise the Platform.
The following drawing shows the Release Cam below the Lock Block.
The Release Cam has not passed over the Lock Block; the Lift would
not
go on a Safety Lock at
this point.
When the Release Cam goes past a Lock Block, it makes an audible click when it hits the Base.
2. To use that Safety Lock, keep pressing Up for another half a second, then release Up.
To Next Page
Loading...
