MD-6XP Mid-Rise Scissor Lift 3 P/N 5900108 — Rev. F — March 2020
Table of Contents
Introduction 3 Operation 25
Shipping Information 4 Maintenance 33
Safety Considerations 4 Troubleshooting 34
FAQs 6 Wiring Diagrams 35
Components 7 Labels 36
Specifications 8 Parts Diagrams 39
Installation Checklist 10 ALI Store 43
Installation 11
Introduction
This manual describes the MD-6XP, which is a mid-rise, frame-engaging, scissor Lift that is portable
and comes with a small footprint designed for narrower bays and low-ceiling garages.
The MD-6XP can raise Vehicles up to 6,000 lbs (2,722 kg).
More information about the full line of BendPak products is available at bendpak.com.
This manual is mandatory reading for all MD-6XP users, including anyone who sets up, operates,
maintains, or repairs them.
⚠ DANGER Be very careful when setting up, operating, maintaining, or repairing this equipment;
failure to do so could result in property damage, product damage, injury, or (in very
rare cases) death. Make sure only authorized personnel operate this equipment. All
repairs must be performed by an authorized technician. Do not make modifications
to the unit; this voids the warranty and increases the chances of injury or property
damage. Make sure to read and follow the instructions on the labels on the unit.
Keep this manual on or near the device so that anyone who uses or services it can read it.
If you are having issues, refer to the Troubleshooting section of this manual for assistance.
Technical support and service is available from your dealer, on the Web at bendpak.com/support,
by email at support@bendpak.com, or by phone at (800) 253-2363, extension 196.
You may also contact BendPak for parts replacement information (please have the model and serial
number of your unit available) at (800) 253-2363, extension 191.
To Next Page
Loading...
