Operation38
FUNCTION
(default setting/
value)
DESCRIPTION (default setting/value)
Picture Mode
(Brightest)
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See "Selecting a
picture mode" on page 28 for details.
Reference
Mode
(Brightest)
Selects a picture mode that most suits your need for the image quality
and further fine-tune the image based on the selections listed on the
same page below. See "Setting the User mode" on page 29 for details.
Brightness
(50)
Adjusts the brightness of the image. See "Adjusting Brightness" on
page 30 for details.
Contrast
(0)
Adjusts the degree of difference between dark and light in the image.
See "Adjusting Contrast" on page 30 for details.
Color
(0)
Adjusts the color saturation level -- the amount of each color in a
video image. See "Adjusting Color" on page 30 for details.
Tint
(0)
Adjusts the red and green color tones of the image. See "Adjusting
Tint" on page 30 for details.
The function is only available when Video with NTSC system is
selected.
Sharpness
(15)
Adjusts the image to make it look sharper or softer. See "Adjusting
Sharpness" on page 30 for details.
Color
Temperature
(T1)
See "Selecting a Color Temperature" on page 30 for details.
Save Settings
Saves the settings made for User mode.
2. PICTURE menu
To Next Page
Loading...
