Operation
42
To adjust the settings:
1. Go to the PICTURE menu and select 3D Color Management.
2. Press MODE/ENTER and the 3D Color Management page displays.
3. Select Primary Color and press / to select a color from among Red, Yellow,
Green, Cyan, Blue, or Magenta.
4. Press to select Hue and press / to
select its range. Increase in the range will
include colors consisted of more
proportions of its two adjacent colors.
Please refer to the illustration to the right
for how the colors relate to each other.
For example, if you select Red and set its
range at 0, only pure red in the projected
picture will be selected. Increasing its range
will include red close to yellow and red close
to magenta.
5. Press to select Saturation and adjust its
values to your preference by pressing / . Every adjusent made will reflect to the
image immediately.
For example, if you select Red and set its value at 0, only the saturation of pure red
will be affected.
• Saturation is the amount of that color in a video picture. Lower settings produce less saturated colors;
a setting of “0” removes that color from the image entirely. If the saturation is too high, that color will be
overpowering and unrealistic.
6. Press to select Gain and adjust its values to your preference by pressing / .
The contrast level of the primary color you select will be affected. Every adjusent
made will reflect to the image immediately.
7. Repeat steps 3 to 6 for other color adjusents.
8. Make sure you have made all of the desired adjusents.
9. Press MENU/EXIT to exit and save the settings.
Resetting current or all picture modes
1. Go to the PICTURE menu and select Reset Picture Settings.
2. Press MODE/ENTER and press / to select Current or All.
• Current: returns current picture mode to the factory preset settings.
• All: returns all settings, except User 1/User 2 in the PICTURE menu to the
factory preset settings.
RED
BLUE
GREEN
Yellow
Cyan
Magenta
To Next Page
Loading...
