Operation
62
Using the broadcassting function
When it comes to 1:N LAN Dispaly,there are two ways to do this function:
1. By TCP/IP (support up to 8 porjectors, original design)
2. By Multicast(support up to 255 projectors, this new design)
You can select channel 1, 2, 3, 4, 5,6...25 with showing the corrspondent IP(gray out).
There are 1~25 channels (25IPs) for you to select freely:
239.192.19.21~239.192.19.45
If the channel is fixed at emergency channel, when projector detects image coming in from
this channel, it will project this image automatically. There is no need to switch sources
manually.
To acticate this function:
The function requires special version of the QPresenter. Please download it from your User
Manuel CD.
1. Go to the SYSTEM SETUP: Advanced > Network Settings menu after
opening the OSD menu system. Press MODE/ENTER.
2. Press to select Broadcasting and press / to select On.
3. Open the Advanced Settings page in the Qpresenter.
4. Click Yes in the Activating Broadcasting row and click Apply.
Or
1. Open the Projector Network Display System and go to the Basic page.
2. Click On in the Broadcasting row and select a channel using the drop-down list.
3. Open the Advanced Settings page in the Qpresenter.
4. Click Yes in the Activating Broadcasting row and click Apply.
• This function is only available when the Network Display source is selected.
• The minimum system requirement for your computer is Intel Core 2 Dou 2.4GHz CPU, 2G
DDR.
To Next Page
Loading...
