Operation
43
Setting the presentation timer
The presentation timer can indicate the presentation time on the screen to help you
achieve better time management when giving presentations. Follow these steps to utilize
this function:
1. Go to the SYSTEM SETUP: Basic > Presentation Timer menu and press
MODE/ENTER to display the Presentation Timer page.
2. Select Timer Period and decide the timer period by pressing / . The length of
time can be set from 1 to 5 minutes in 1-minute increments and 5 to 240 minutes in
5-minute increments.
3. Press to select Timer Display and choose if you want the timer to show up on
the screen by press
ing / .
4. Press to select Timer Position and set the timer position by pressing / .
Top-Left Bottom-Left Top-Right Bottom-Right
5. Press to select Timer Counting Direction and select your desired counting
direction by pressing /
.
6. Press to select Sound Reminder and decide if you want to activate sound
reminder by pressing / . If you select On, a double beep sound will be heard at
the last 30 seconds of counting down/up, and a triple beep sound will be produced
when the timer is up.
7. To activate the presentation timer, press and press / to select On and press
MODE/ENTER.
8. A confirmation message displays. Select Yes and press MODE/ENTER to confirm.
You will see the message “Timer is On” displaying on the screen. The timer starts
counting at the time the timer is on.
To cancel the timer, perform the following steps:
1. Go to the SYSTEM SETUP: Basic > Presentation Timer menu and press
select to select Off. Press MODE/ENTER. A confirmation message displays.
2. Select Yes and press MODE/ENTER to confirm. You will see the message “Timer
is Off!” displaying on the screen.
Selection Description
Always Displays the timer on screen throughout the presentation time.
1 Min/2 Min/3 Min Displays the timer on screen in the last 1/2/3 minute(s).
Never Hides the timer throughout the presentation time.
Selection Description
Count Up Increases from 0 to the preset time.
Count Down Decrease from the preset time to 0.
To Next Page
Loading...
