49 Web management
Pairing
Click Pairing and you will see Pairing and Pairing Status.
Pairing is used when the Host is attached to the ceiling as it is not easy to press the PAIRING key
of the Host when the device is high on the ceiling. You can pair a Button and Host via the web
management interface.
1. Connect the Button’s USB-C™ jack to the corresponding ports of a laptop.
2. When the Button is successfully connected to the laptop, the LED indicator of the Button will
blink green.
3. Make sure the Host is properly connected to a power source.
4. Enable the 2.4G Wi-Fi channel in the Wi-Fi Radio Setup menu.
USB-C™
To Next Page
Loading...
