17
®®
Section 2 - Identification of Components
Table 2.2 - Identification of the Switching Power Supply Components
Part Description
18c Cable Tie Bases
19a Mains Screw Terminal — for Mains and Earth
19b General protection Fuse: F500MA - 250
19c Adhesive Label
20a BAQ35T12 Switching Power Supply
20b BAQ15T12 Switching Power Supply
21 Mains LED (ON = Mains OK)
22a Fine Adjustment Trimmer
22b
KST Jumper — If you are connecting a KST Thermal Probe to the battery, this
jumper must be inserted.
23 A uxiliary Terminals for system peripheral (Output = 13.8 Vcc)
24
Screw to secure the Switching Power Supply to the backplate:
1 x BAQ35T12 - 2 x BAQ15T12
25a Screw for the Switching Power Supply
25b Snap Rivet
26 Thermal probe — to be fitted to the battery (Order Code: KST)
27 Fuse — protects Switching Power Supply (F2A-250V)
28 Fuse — protects against Battery polarity inversion (F6.3A-250V)
29a Connector for the Switching Power Supply
29b OVC-Link wire (Output Voltage Control)