Berges ACP micro 3000 - Optional Connections

76 pages

Save Page as PDF

To Next Page

To Previous Page

21.12.98 Operating manual

04_GB ACP 3000 — 0.37–15.0

Berges electronic • D–51709 Marienheide-Rodt • Tel. 02264/17-0 • Fax 02264/17126

7.7 Optional Connections

StockCheck.com

Main Page

Table of Contents5
General Information7
Explanation of Symbols and Notes7
Safety and Operating Instructions for Drive Converters7
Preface9
Technical Data10
Model Identification Number10
Power Specifications10
General Drive Specifications11
Dimensional Data (Size I)12
Dimensional Data (Size II)13
Dimensional Data (Size III)13
Dimensional Data (Size IV)14
Installation15
Inspection15
General Rules for Installation15
EMC (Electromagnetic Compatibility)16
Suggestion on How to Solve the Problem of Radio Frequency Interference Suppression of Frequency Converters to VDE 0875/EN 5501116
Mains Filters/Output Chokes17
Filter Specifications18
Interference Suppression Measures19
EMC Ordinance (EMC Directive, 89/336 EEC)21
Wiring Practices22
Applicable Codes22
Power Wiring22
Control Wiring/Interface22
Mains Power Connection23
Mains Conditions24
Line Protection25
Using Mains Filters26
Line Starting27
Motor Connection27
Reducing Current Surges and Voltage Transients27
Function and Use of Terminals28
Terminal Access Cover Removal29
Terminal Assignment (Mains Supply 1 × 230 VAC, 0.37-4.0 Kw)30
Terminal Assignment (Mains Supply 3 × 400 VAC, 0.37-4.0 Kw)30
Terminal Assignment (Mains Supply 3 × 400 VAC, 5.5-15.0 Kw)31
Remote Keypad/Program Memory Unit Connector (J22)31
Control Terminal Description31
J20 Configuration33
Getting Started34
General Information34
Digital Keypad34
Keypad Operation34
Operation Mode (RUN and STOP Modes)35
Program Mode35
Status Indicator36
Description of Displays36
Programming Tips37
Quick Start38
Parameter Configuration and Description39
Programming39
Parameter Descriptions39
PI Controller55
Introduction55
Overview of PI Control55
Reference and Feedback Inputs57
Calculating PI Controller Values58
Parameters for PI Control58
Connection Diagrams62
AC Line and Motor Connections (Mains Supply 1 × 230 VAC and 3 × 400 VAC)62
2-Wire Run/Stop Connections63
Auxiliary Relay Output and Digital Output ST163
MOL Terminal Connections64
Analog Speed Input Connections (VIN1/VIN2)64
Optional Connections65
Troubleshooting66
Special Indications66
Fault Trip Indications66
Resetting a Fault67
Fault Codes67
Appendix69
Parameter Code Summary69
Parameters Added or Amended When PI Control Is Utilized71
Options71

Berges ACP micro 3000 - Optional Connections

Table of Contents

Related product manuals