6
1 SAFETY
This device complies with current applicable safety standards.
The installation, maintenance, and use of this unit require a skilled
and trained personnel.
Please carefully read this whole document before mounting and
powering the actuator.
2 PACKAGING, STORAGE AND MAINTENANCE
2.1 Packaging
The AT actuator packaging is comprised of a corrugated, double wall
cardboard box strapped on a pallet. For certain non-EU countries or
upon request, the pallets are heat treated to the NIMP 15 standard
and IPPC-stamped.
This packaging is identical for shipping by road, air or sea, unless
otherwise mentioned in the contract.
2.1.1 Check identification sticker
The information on the nameplate sticker on the side of the actuator
should match your order.
The QR code on this sticker can be used to identify the actuator.
2.2 Storage
Actuators should be stored under a shelter, in a clean and dry place,
and at a stable ambient temperature.
• Avoid placing the actuator directly on the floor.
• Check that the cable entry plugs are correctly tightened.
• Check that the cover screws are correctly tightened to ensure
weatherproof sealing of the cover.
AT actuators include electrical components and lubricated gears. If
the actuator is incorrectly stored, regardless of its weatherproof
enclosure, alterations may occur, such as oxidation, galling, and
other.
The heating resistance should be connected to the power supply,
especially if the storage place is wet.
To Next Page
Loading...
Need help?
General