Bernina 700D - TWO THREAD FLATLOCK STITCH

MASTERING YOUR BERNINA
®
1/04/02 700D/800DL/64
BERNINA
®
700D/800DL
MASTERING
YOUR
BERNINA
®
Fabric: Medium weight cotton, 4” x 6”
Needle: 80/12 Stretch
Thread: 1 cone of serger thread
1 cone of Jeans Stitch
®
Presser Foot: Standard
TWO THREAD FLATLOCK STITCH
• Owner’s manual pg.___
• Attach the 2-thread adapter to the upper looper. Note: This is an optional accessory for the 700D.
• Set all thread tension levers between 3-5 (normal).
• Following the instructions in the Owner’s manual thread the serger for a 2-thread flatlock stitch using
Jeans Stitch
®
in the lower looper. Set tension levers as directed.
• Adjust the stitch length to 2.5mm.
• Fold the fabric in half to 2” x 6” and position it halfway between the left needle and the stitch finger.
Optional: Attach the Attachment Base and the Right Seam Guide. Move the Right Seam Guide
halfway between the needle and the stitch finger.
• Slowly serge the fabric. The looper threads will extend beyond the fabric on the right side of fold.
• Gently pull the fabric flat
• Return stitch length and thread tension levers to normal.
• Trim and mount the sample.