6. Software Functions LB 124 Scint
48
6.3 Measurement Mode
The measurement mode is selected on this menu. This setting
refers to the two menus Measurement and Measurement Pa-
rameters.
The Parameters displayed on the menu Measurement Pa-
rameters are valid only for the preset measurement mode.
Modifications are also stored depending on the measurement
mode. The measurement mode started on the Measurement
menu is also determined on the Measurement Mode menu.
Example: Scaler-Timer is set.
If Measurement is selected, a scaler-timer measurement is
carried out using the parameters which have been preselected
on the Measurement Parameters menu. Furthermore, all gen-
eral parameters are activated, for example: background value
(or autostart); nuclides and nuclide parameters. If the meas-
urement parameters are modified and stored on the Measure-
ment Parameters menu, they are only allocated to the scaler-
timer mode.
Procedure On the System Menu, the currently set measurement mode is
displayed next to the option Measurement Mode.
In order to modify the setting, select the option Measure-
ment Mode (Æ) and push the
button. After that the
current setting is marked by a bar.
Press the
key repeatedly to scroll through the select-
able measurement modes in a cyclical order.
If the desired measurement mode is displayed, press the
key to confirm the selected setting.
Figure 25: Measurement mode selection
To Next Page
Loading...
