LB 124 Scint 7. Maintenance
77
7.3 Exchanging the Battery
The device needs three dry batteries, type C, baby (IEC LR 14,
with 1.5 volt each). The serviceable life of a fresh set of high
output cells is more than 50 hours of continuous operation
(without lighting and without RS232 communication). When the
device is delivered, a set of reserve batteries is provided in ad-
dition to the batteries in the device.
The batteries are located on the back of the monitor in the bat-
tery case, which is covered with a cover plate. The fixing screw
can easily be unscrewed with the help of a coin. The batteries
are replaced as described on page 11 of this manual.
After the replacement, secure the batteries with the cover plate.
If the device is run with almost dead batteries, it will be switched
off automatically, as soon as the battery voltage is not sufficient
for correct operation any more. In this case, the device cannot
be restarted without exchanging the batteries.
Remove the batteries from the device when it is not used for a
rather long period of time, e.g. several months.
To Next Page
Loading...
