Safety Instructions LB 124 Scint
IV
Safety instructions
Use and function The digital contamination monitor LB 124 Scint can be widely
and flexibly used for contamination measurements in radiation
protection.
It is used wherever contamination caused by radioactive sub-
stances is encountered and has to be monitored:
in medical nuclide laboratories, in nuclear research, in nuclear
power plants, as well as the environment in general.
Safety instructions If official regulations exist concerning the installation and/or op-
eration of radiation measurement devices, the operator must
ensure that these regulations are complied with.
The manufacturer has undertaken everything to ensure the safe
operation of the instrument. The user has to make sure to use
and handle the LB 124 Scint in such a manner that the safe op-
eration is not endangered.
In particular, this applies to:
The sensitive window foil of the counter tubes:
• Whenever you are measuring uneven or pointed objects, be
careful not to damage the foil.
To be able to handle the monitor LB 124 Scint properly and ac-
cording to its intended use, one has to have a thorough knowl-
edge of the operating manual. Although the handling is very
easy, you should nevertheless read the manual.
In order to make sure that the device works properly, please fol-
low the manufacturer’s instructions concerning the functional
checks and maintenance work.
All maintenance and repair work exceeding the steps described
in the operating manual must only be carried out by B
ERTHOLD
TECHNOLOGIES or else by technicians authorized by BERTHOLD
TECHNOLOGIES.
To Next Page
Loading...
