Adjusting Parameters
Precellys
®
24
Page 20/35
6.2.2 Adjusting the Number of Cycles
Once the speed is adjusted, the following message displays on the screen and the number of cycles
flashes:
6200-
2
2x45-020
RUN NUMBER
Red light is off / green light is on
The user can change the number of cycles using the “Up” and “Down” buttons. The number of
cycles ranges from 1 to 3.
When the desired value is reached, the user can select it by pressing the “Valid” button or return to
the previous menu by pressing the “Cancel” button.
6.2.3 Adjusting the Duration of the cycle
Once the number of cycles is adjusted, the following message displays on the screen and the
duration of the cycle flashes:
6200-3x
45
45-020
RUN TIME (s)
Red light is off / green light is on
The user can change the cycle’s duration using the “Up” Down” buttons. The cycle’s duration
ranges from 5 seconds to 90 seconds in increments of 1 second.
When the desired value is reached, the user can select it by pressing the “Valid” button or return to
the previous menu by pressing the “Cancel” button.
To Next Page
Loading...
Need help?
General
