ENGLISH Gold/Plus/Easy refrigerated cabinets
64
Ed. 12/2020
– take the bracket off the lower door (4) by removing the screws(9);
– then, remove the bushing (10);
m
BE CAREFUL
The lower bracket (4) has two square holes on both sides. Mark which ones to use because the same
bracket should then be mounted on the opposite side of the door opening to the left.
– remove the screws (11) of the door spring bracket, then slide the entire spring unit from the bottom of the door
(12);
– take the bracket off the upper door(5)as indicated for the lower door;
– remove the support cap from both doors (13) and put it back on the other end in place of the spring block;
13
9
11
9
12
10
4
5
11
10
12
Fig. 17
– on the lower door, assemble the previously removed spring block (12)in the hole left by the support cap, securing
it in place with the screws (11);
– then, reassemble the bushing (10) and lower bracket (4) turning it 180° before positioning it;
– use the screws (9) to secure the bracket in place which will remain slightly open towards the inside;
– on the upper door, assemble the previously removed spring block (12)in the hole left by the support cap, securing
it in place with the screws (11);
– then, reassemble the bushing (10) and the new upper bracket (1);
– use the screws (9) to secure the bracket in place which will remain slightly open towards the inside;
9
11
4
10
12
180°
9
12
10
1
11
Fig. 18
To Next Page
Loading...