Rev 9 2022
25
Maintenance & Repair Solenoid Replacement
11. Pull the connector and wire through the frame
of the machine
12. Pull the plunger from the solenoid
13. Remove 4 screws from the solenoid shelf
14. Remove the nut holding the solenoid plunger
15. On new solenoid shelf parally insert the back 2
screws so it can hang freely
16. Install the new plunger
17. Reinsert the plunger into the solenoid body
18. Align the solenoid shelf and replace the 2
front screws
19. Tighten down all screws on the solenoid shelf
20. Reinstall the spring
21. Replace the access plate
22. Reinstall the bae safety
23. Snap the tank shelf back into place
24. Replace the right cover (5 Philips screws)
25. On le cover plug keypad ribbons back into
controller board
a. Be sure not to miss any pins as this will eect
the length selected
26. Reinstall le cover be sure not to pinch or drive a
screw through the keypad ribbons.
27. Replace water tank, brushes, and water bole
Connued
To Next Page
Loading...
