Better Packages 555e - Tape Strips Too Short

8
Rev 9 2022
Troubleshoong Tape Strips Too Short
The machines measures the tape length by counng the number of pulses from the length encoder. Each me one of
the small cutouts in the encoder wheel passes in front of the opcal switch a pulse is produced. When the programmed
number of pulses is reached the machine turns o the motor and cuts the tape. The most likely cause for short lengths
is the feed wheel slipping on the tape.
• Slippage
If the blade height is not adjusted correctly sucient pressure may not be exerted on the tape by the feed wheel.
To test this:
1. Open the cover and insert a strip of tape under the Feed Wheel, as if you are loading tape.
2. To the right is a small lever, li up on this lever. The Blade should rise when this happens.
3. Aempt to pull the tape out from under the Feed Wheel.
a. If it removes too easily the Feed Wheel will need to be ghtened
b. If you cannot remove the tape the Feed Wheel is too ght and will need to be loosened.
c. If the tape can be removed with a constant pull force pull force, clean the feed wheel
Adjust blade height if needed.
Reference the secon Feed Wheel / Blade Height Adjustment for instrucons
A dirty or oily feed wheel may slip on the tape. Clean the surface of the feed wheel that contacts the tape with a mild
cleaner and a clean cloth.
If le hand corner of tape is folded over the blade is not high enough for the tape to pass through unobstructed, adjust
the blade height.