BM3 Installation & User Manual 15
ENG
Setting a password
The first thing to do is to set a password. You
will later use the password each time you want
to programme the Bewacom.
Open the Bewacom and turn it around so
the circuit board can be seen.
Press the SW1 button (see the wiring dia-
gram). ll
Enter the desired 6-digit password.
mm
Make a note of the password and store the
note in a safe place.
Setting Bewacom to programming mode
To programme a function, set Bewacom to pro-
gramming mode.
Press and hold the B button on the Bewa-
com keypad until the beeper goes off an the
yellow LED goes out (approx 3 seconds).
Enter the 6-digit password.
ll
1�
2�
3�
4�
1�
2�
To Next Page
Loading...
