24 BM3 Installation & User Manual
ENG
Erasing the memory
Using this function all programmed information
in the Bewacom can be erased and the unit set
back to factory defaults.
Set Bewacom to programming mode.
Open the Bewacom and turn it around so
the circuit board can be seen.
Press the SW1 button (see the wiring dia-
gram on page 10).
Press 112186 on Bewacom’s keypad.
Press 112186 again.
Bewacom now has the default settings:
Password: 112233
Opening time: 7 seconds
Calling time: 30 seconds
Door release from telephone: 0
Background lighting: ON
Internal sounder: ON
Possibility to call into Bewa-
com:
OFF
Hotline: OFF
Extended opening time: OFF
Extended calling time OFF
1�
2�
3�
4�
5�
To Next Page
Loading...
