Bewator BM3 - Programming the Bewacom Unit; Programming Feedback Indicators

14 BM3 Installation & User Manual
ENG
Programming
The sections below describe how to programme
Bewacom.
Internal sounder and LEDs
During programming, guidance will be given by
the internal sounder and the LEDs.
In the manual the LED indications are shown as
follows:
m = OFF l = Lit  Flashes
In programming mode before a function is
chosen: Red and yellow LED flashes.
During programming: The LEDs are lit or off
depending on the function being programmed.
Correct programming: Confirmed by a rising
signal – two quick beeps.
Faulty programming: Confirmed by a falling
signal – two quick beeps.
NOTE!
Once programming mode has been
entered, if a key is not pressed within 15
seconds, the unit will return to normal
operation.