BM3 Installation & User Manual 17
ENG
Changing access codes
Set Bewacom to programming mode.
Enter the access code to change.
Enter the new access code.
Enter the new access code again.
To only change the code – without changing
the time control group – press B now.
If the code is not timed, press 0.
If the is timed, select the desired input (see
below).
1 = the code can be timed from a time clock
connected to input 1.
2 = the code can be timed from a time clock
connected to input 2.
Also see the wiring diagram.
Follow steps 2-5 to change the next code.
Press B to exit programming.
1�
2�
3�
4�
5�
6�
7�
To Next Page
Loading...
