16 BM3 Installation & User Manual
ENG
Programming access codes (first time)
Four different 4-digit entrance codes can be
programmed.
Set Bewacom to programming mode.
Press 0000.
Enter the desired access code using 4 dig-
its.
Enter the code once again.
If the code is not to be time controlled,
press 0.
If the code is to be time controlled, select
the desired input (see below).
1 = the code can be timed from a time clock
connected to input 1.
2 = the code can be timed from a time clock
connected to input 2.
Also see the wiring diagram.
Follow steps 2-5 to programme the next
code.
Press B to exit programming.
1�
2�
3�
4�
5�
6�
7�
To Next Page
Loading...
