Bewator BM3 - Change Number of Digits in the Extension

BM3 Installation & User Manual 23
ENG
button is pressed. No other number is permit-
ted at this point (the keyboard is disabled).
The telephone system is then programmed to
respond to this ”hotline” condition.
To enable this function.
Set Bewacom to programming mode.
Press A67.
Press 1 to enable hotline.
Press B to leave programming mode.
To deactivate the function, press 0 in step 3
instead.
Change number of digits in the extension
In some cases the PABX requires more than four
digits in the extension number. You can select
how many by doing as below:
Set Bewacom to programming mode.
Press A92
Enter the number of digits with two digits
(01-99)
Press B to leave programming mode.
1�
2�
3�
4�
1�
2�
3�
4�