18 BM3 Installation & User Manual
ENG
Erasing access codes
To erase a programmed access code:
Set Bewacom to programming mode.
Enter the access code to erase.
Enter 0000.
Enter 0000 again.
Press B.
Press B to exit programming.
Changing the door unlock time
When Bewacom is delivered the door unlock
time is set to 7 seconds.
Set Bewacom to programming mode.
Press A28.
Select the required unlock time in seconds
(01-99).
Press B to exit programming.
Extending the opening time 10 times
Using this function the door unlock time can be
increased by a factor of ten.
Set Bewacom to programming mode.
Press A64.
1�
2�
3�
4�
5�
6�
1�
2�
3�
4�
1�
2�
To Next Page
Loading...
