Bewator BM3 - Page 25

BM3 Installation & User Manual 25
ENG
Programming overview
Always start by pressing B and enter the programming code. Abort: Press B. Function Step 1 Step 2 Step 3 Step 4 Step 5 Program access- code
Press 0000 Enter new
code (four digits)
Enter the code once again
Enter time control group 0 = no 1 = group 1 2 = group 2
Next code: Carry on from step 1. Abort: Press B (returns to program- mering mode).
Change ac- cess code
Enter code to change
Enter new code (four digits)
Enter the code once again
Enter time control group 0 = no 1 = group 1 2 = group 2
As above
Erase ac- cess code
Enter code to erase
Press 0000 Press 0000
igen
Press B. Press B to exit.
Change opening time
Press A28 Enter open-
ing time (01-99)
Press B to exit.