INSTALLATION COMFORT AIR CURTAIN
30
2.9.2 Finishing recessed models
General
Note:
n Ensure that the unit remains accessible for maintenance
and repair through, for instance, an inspection hatch.
1
Adjusting the discharge duct
If linking two or more units to each other
, you must adjust the
discharge duct so that the finishing edges will not be in each
other’s way.
1. Remove the end piece with finishing edge 1.
2
2. Mount the end piece without finishing edge 2.
3
4
Installing the discharge duct
3. Make a hole in the ceiling for the discharge (for
dimensions, see T
able 2-3).
4. Fix the two angle sections3 with sheet metal screws to
the unit, along
the edges of the discharge opening.
5. Slide the discharge duct 4 into the discharge opening until
the desir
ed height is reached.
To Next Page
Loading...