OPERATION COMFORT AIR CURTAIN
42
9. Calibration An unfavourable position of the operating panel or using the
temperature sensor in the air curtain can be the reason why
the temperature displayed differs from the real temperature.
Use this function to adjust the temperature reading.
11. Standard settings Restores the standard factory settings. The settings made in
the
Configuration menu are retained.
3.9 Configuration
The Configuration menu allows you to make settings to adjust
the operation of the unit to the room and the system. Usually,
this level is used only for installation, maintenance and service
purposes.
50. Access protection Access to the whole operating panel or only to the menu can
be protected with a four-digit PIN code.
The default PIN code is 0000.
51. Indoor sensor Both the unit and the operating panel have a sensor which
measures the indoor temperature. Choose one that the
system is to use:
• Select the sensor on the unit for automatic control. This is
the standard setting.
• Select the sensor on the control panel if you also wish to
use the air curtain for heating the room. In this case
comfort may be reduced by draughts along the floor.
52. Function of ON/OFF button The unit can be switched ON and OFF manually. It can also be
switched ON and OFF via the internal timer or via an external
release signal at the input of the operating panel or of the unit.
In this case you can disable the manual switching ON and OFF.
The
ON/OFF button is then not displayed on the Home screen.
53. Control panel input The control panel has one input signal interface. This can be
used for an external ON/OFF signal or for an additional
temperature sensor.
When the timer is in use, the ON/OFF function of the input of
the control panel is deactivated, irrespective of this setting.
If an additional temperature sensor is connected, this takes
over the function of the sensor in the control panel.
To Next Page
Loading...