BIGTREETECH CB2 - SSH Connect to Device

BIGTREETECH CB2 User Manual
6. SSH Connect to Device
1. Install the SSH software Mobaxterm: https://mobaxterm.mobatek.net/download-
home-edition.html
2. After powering on, wait for the system to boot, which typically takes about 1 to 2
minutes.
3. Once the device is connected to WiFi or an Ethernet cable is plugged in, it will
automatically be assigned an IP address.
4. Access the router management interface to find the device's IP (it should be BTT-
CB2 here).
5. Open Mobaxterm and click "Session", and click "SSH", inset the device IP into
Remote host and click "OK" (Note: your computer and the device needs to be in
the same network).
6. Login as: biqu password: biqu