BIGTREETECH MMB CAN V1.0

BIGTREETECH MMB CAN V1.0 User Manual
11
[*] Enable extra low-level configuration optionsMicro-controller
Micro-controller Architecture (STMicroelectronics STM32) --->
Processor model (STM32G0B1) --->
If not using CanBoot
Bootloader offset (No bootloader) --->
If CanBoot is used
Bootloader offset (8KiB bootloader) --->
If USB communication on Type-C is used
Communication interface (USB (on PA11/PA12)) --->
If CAN-Bus communication is used
Communication interface (CAN bus (on PB0/PB1)) --->
(1000000) CAN bus speed
2. After configuration, press q to exit, and select Yes when prompted to
save.
3. Enter make to compile the firmware. The resulting klipper.bin file will be
in the home/pi/klipper/out folder. This can be directly downloaded to
your computer from the SSH software's left panel.