EasyManuals Logo
Home>BIGTREETECH>Computer Hardware>MMB CAN V1.0

BIGTREETECH MMB CAN V1.0 User Manual

BIGTREETECH MMB CAN V1.0
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
BIGTREETECH MMB CAN V1.0 User Manual
13
The Application should now show Klipper, indicating it is running correctly.
Firmware Update via DFU
Raspberry Pi or CB1 update via DFU.
1. Hold the Boot button and connect the board to Raspberry Pi/CB1 via
Type-C cable to enter DFU mode.
2. Enter lsusb in the SSH terminal to query the DFU device ID.
3. Enter
cd klipper
navigate to the Klipper directory, and enter
make flash FLASH_DEVICE=0483:df11
start flashing the firmware (Note: Replace 0483: df11 with the actual
device ID found in the previous step.)
4. After flashing, enter
ls /dev/serial/by-id/
to query the device's Serial ID (only applicable for USB communication,
not for CANBus).
5. For USB communication, you don't need to press the Boot button for
subsequent updates. Enter the following command to flash the firmware
make flash FLASH_DEVICE=/dev/serial/by-id/usb-Klipper_stm32g0b1xx_4550357128922FC8-if00
(Note: replacing /dev/serial/by-id/xxx with the actual ID found in the
previous step).
6. For CAN bus communication, disconnect the Type-C cable after flashing.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BIGTREETECH MMB CAN V1.0 and is the answer not in the manual?

BIGTREETECH MMB CAN V1.0 Specifications

General IconGeneral
BrandBIGTREETECH
ModelMMB CAN V1.0
CategoryComputer Hardware
LanguageEnglish

Related product manuals