Binder KB 23 - Page 39

KB 23 / KB 23-UL (E3.1) 02/2019 page 39/87
When deactivating the week program timer, any programming made in advance will
remain in memory and take effect when the week program timer is activated again.
Deactivate the week program timer before entering set-points in fixed value entry mode
(chap. 6). Otherwise, any setting of the operation lines is ineffective.
Deactivate the week program timer before staring a program (chap. 9).
• Display mode (12h/24h)
Select between 12 hours (display “AM” or “PM”) or 24 hours.
• Date of the real time clock (Date)
Main menu. Use the program key to access the settings of year, month, and day in the corresponding
submenus.
• Year of the real time clock (Year)
Enter the year (2006 up to 2050)
• Month of the real time clock (Month)
Enter the month (1 up to 12).
• Day of the real time clock (Day)
Enter the day (1 up to 31).
• Time of the real time clock (Time)
Main menu. Use the program key to access the settings of hour and minute in the corresponding
submenus.
There is no automatic switch between daylight saving time and regular time.
• Hour of the real time clock (Hour)
Enter the hour (0 up to 23).
• Minute of the real time clock (Minute)
Enter the minute (0 up to 59).