Repair work at electric and electronic components
Spare parts:
Electric mounting plate, standard
KBF 115, 240, 720, Electric mounting plate, complete (order no. 8007-0339)
Necessary
tools
Crosstip screwdriver, size 2
Torx screwdriver, size T20
1. Disconnect the unit from the power supply.
2. Remove the housing cover on the lower front (chap. 5.1).
3. Remove the fixing screws from the corresponding electric mounting plate (A; B).
To remove the electric mounting plate (option) (A) you need to unscrew all lateral control
panels.
4. Pull the electric mounting plate out of the machine room as far as possible due to the cable lengths.
5. Mount the electric mounting plate by following steps 1 to 4 in reverse order.
6.
Figure 37: Pulling the electric mounting plate out of the machine room
A Electric mounting plate (option)
B Electric mounting plate (standard)
Service Manual KBF (E5.2) 04-2015 81
To Next Page
Loading...
