Field Description
• 5$1 A 7( : Route via a specific gate-
way which is used if no other adequate route is available.
• @ A $%: Route to a single host via a
specific interface.
• @ A 7(: Route to a single host via a
specific gateway.
• )79 A $%: Route to a network via
a specific interface.
• )79 A 7( (default value): Route to a
network via a specific gateway.
Destination Interface Select the IPv6 interface to be used for this route.
You can choose from those interfaces available under LAN->IP
Configuration->Interfaces->New that are IPv6-enabled.
Source Address /
Length
Enter the source IPv6 address along with the corresponding
prefix length.
88 describes an unspecific address.
By default the prefix length is predefined.
Destination Address /
Length
Enter the destination IPv6 address along with the corresponding
prefix length.
88 describes an unspecific address.
By default the prefix length is predefined.
Gateway Address Enter a the IPv6 address for the next hop.
Metric Select the priority of the route.
The lower the value, the higher the priority of the route.
Value range from to . The default value is .
10 Networking bintec elmeg GmbH
232 bintec RS Series
To Next Page
Loading...
