Field Description
203)8 -+ '
Select the WLAN module on which to perform the frequency
band scan.
WLC SSID
Only where Command Type = 2068 E 
Select the wireless network administered over the WLAN con-
troller whose status should be changed.
Operation Mode (Act-
ive)
Only where Command Type = 203)8 -+ '
Select the required operating mode for the selected radio mod-
ule if it currently has the status 3%. You may select from
any of the operating modes that your device supports. So the
choice may vary from device to device.
Operation Mode (In-
active)
Only where Command Type = 203)8 -+ '
Select the required operating mode for the selected radio mod-
ule if it currently has the status 57. You may select from any
of the operating modes that your device supports. So the choice
may vary from device to device.
17.8.3 Options
You configure the schedule interval in the Local Services->Scheduling->Options.
Fig. 190: Local Services->Scheduling->Options
The Local Services->Scheduling->Options menu consists of the following fields:
Fields in the Scheduling Options menu.
Field Description
Schedule Interval Select whether the schedule interval is to be enabled for the in-
17 Local Services bintec elmeg GmbH
502 bintec RS Series
To Next Page
Loading...
Need help?
General
