Field Description
Loopback active The NAT loopback function also enables network address trans-
lation for connectors whereby NAT is not activated. This is often
used in order to interpret queries from the LAN as if they were
coming from the WAN. You can use this to test the server ser-
vices.
The function is disabled by default.
Silent Deny Select whether IP packets are to be silently denied by NAT. If
this function is deactivated, the sender of the denied IP packet
is informed by means of an appropriate ICMP or TCP RST mes-
sage.
The function is disabled by default.
PPTP Passthrough Select whether the setup and operation of several simultan-
eous, outgoing PPTP connections from hosts in the network are
also to be permitted if NAT is activated.
The function is disabled by default.
If PPTP Passthrough is enabled, the device itself cannot be
configured as a tunnel endpoint.
Portforwardings Shows the number of portforwarding rules configured in Net-
working->NAT->NAT Configuration.
10.3.2 NAT Configuration
In the Networking->NAT->NAT Configuration menu you can exclude data from NAT
simply and conveniently as well as translate addresses and ports. For outgoing data traffic
you can configure various NAT methods, i.e. you can determine how an external host es-
tablishes a connection to an internal host.
10.3.2.1 New
Choose the New button to set up NAT.
bintec elmeg GmbH
10 Networking
bintec RS Series 239
To Next Page
Loading...
Need help?
General
