If possible, access your gateway for filter configuration over the serial console (not
available for all devices) interface or ISDN Login.
10.6.1 Access Filter
This menu is for configuration of access filter Each filter describes a certain part of the IP
traffic and defines, for example, the IP addresses, the protocol, the source port or the des-
tination port.
A list of all access filters is displayed in the Networking->Access Rules->Access Filter
menu.
Fig. 107: Networking->Access Rules->Access Filter
10.6.1.1 Edit or New
Choose the icon to edit existing entries. To configure access fitters, select the New but-
ton.
Fig. 108: Networking->Access Rules->Access Filter->New
bintec elmeg GmbH
10 Networking
bintec RS Series 275
To Next Page
Loading...
Need help?
General
