BinTec RS123 - Page 293

Field Description
See RFC 792.
Connection State
Only if Protocol = *6
You can define a filter that takes the status of the TCP connec-
tions into account.
Possible values:
• 3( (default value): All TCP packets match the filter.
• "1: All TCP packets that would not open any new
TCP connection on routing over the gateway match the filter.
Destination IPv4 Ad-
dress/Netmask
Enter the destination IPv4 address of the data packets and the
corresponding netmask.
Possible values:
• 3( (default value): The destination IP address/netmask are
not specified.
• @: Enter the destination IP address of the host.
• )79: Enter the destination network address and the cor-
responding netmask.
Destination IPv6 Ad-
dress/Length
Enter the destination IPv6 address of the data packets and the
prefix length.
Possible values:
• 3( (default value): The destination IP address/length are
not specified.
• @: Enter the destination IP address of the host.
• )79: Enter the destination network address and the pre-
fix length.
Destination Port/Range
Only if Protocol = *6, .5
Enter a destination port number or a range of destination port
numbers that matches the filter.
Possible values:
• 311 (default value): The filter is valid for all port numbers
• +%$( +: Enables the entry of a port number.
bintec elmeg GmbH
10 Networking
bintec RS Series 277