Field Description
Time within which hosts must respond. The hosts randomly select a
time delay from this interval before sending the response. This
spreads the load in networks with several hosts, improving per-
formance.
Possible values are F to F.
The default value is F.
Robustness Select the multiplier for controlling the timer values. A higher
value can e.g. compensate for packet loss in a network suscept-
ible to loss. If the value is too high, however, the time between
logging off and stopping of the data traffic can be increased
(leave latency).
Possible values are to .
The default value is .
Last Member Query In-
terval
Define the time after a query for which the router waits for an
answer.
If you shorten the interval, it will be more quickly detected that
the last member has left a group so that no more packets for
this group should be forwarded to this interface.
Possible values are F to F.
The default value is F.
IGMP State Limit Limit the number of reports/queries per second for the selected
interface.
Mode Specify whether the interface defined here only works in host
mode or in both host mode and routing mode.
Possible values:
• A# (default value): The interface is operated in Routing
mode.
• @: The interface is only operated in host mode.
IGMP Proxy
12 Multicast bintec elmeg GmbH
298 bintec RS Series
To Next Page
Loading...
Need help?
General
