Field Description
You can configure exceptions for the selected setting in the
Firewall on page 415 menu.
IP Address Mode Select whether your device is to be assigned a static IP address
or whether it should be assigned this dynamically.
Possible values:
• 3 (default value): Your device is automatic-
ally assigned a temporarily valid IP address from the provider.
• % : You enter a static IP address.
Default Route Select whether the route to this connection partner is to be
defined as the default route.
The function is enabled with "1.
The function is enabled by default.
Create NAT Policy Specify whether Network Address Translation (NAT) is to be ac-
tivated.
The function is enabled with "1.
The function is enabled by default.
Local IP Address Only for IP Address Mode = %
Assign an IP address from your LAN to the PPT interface, which
is to be used as your device's internal source address.
Route Entries Only if IP Address Mode = %
Define other routing entries for this PPTP partner.
Add new entries with Add.
• A 3: IP address of the destination host or
network.
• )9: Netmask for Remote IP Address If no entry is
made, your device uses a default netmask.
• '%: The lower the value, the higher the priority of the
route (range of values ... ). The default value is .
bintec elmeg GmbH
13 WAN
bintec RS Series 315
To Next Page
Loading...
