Field Description
• '%: The lower the value, the higher the priority of the
route (possible values ). The default value is .
IP Assignment Pool
(IPCP)
Only if PPTP Mode = ), IP Address Mode =
3
Select a IP pool configured in the VPN->PPTP->IP Pools
menu.
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu.
Field Description
Block after connection
failure for
Enter the wait time in seconds before the device should try
again after an attempt to set up a connection has failed.
The default value is &.
Usage Type If necessary, select a special interface use.
Possible values:
• (default value): No special type is selected.
• '1 . 51 1(!: The interface is defined as
multi-user connection partner, i.e. several clients dial in with
the same user name and password.
Authentication
Select the authentication protocol for this PPTP partner.
Possible values:
• 3: Only run PAP (PPP Password Authentication Protocol);
the password is transferred unencrypted.
• 6@3: Only run CHAP (PPP Challenge Handshake Authentic-
ation Protocol as per RFC 1994); password is transferred en-
crypted.
• 3/6@3: Primarily run CHAP, otherwise PAP.
• ' 6@3: Only run MS-CHAP version 1 (PPP Microsoft
Challenge Handshake Authentication Protocol).
• 3/6@3/' 6@3: Give priority to CHAP, if refused use
the authentication protocol requested by the PPTP partner.
(MSCHAP version 1 or 2 possible.)
14 VPN bintec elmeg GmbH
406 bintec RS Series
To Next Page
Loading...
