EasyManua.ls Logo

BinTec RS123 - Page 485

BinTec RS123
620 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Note
An IPv6 address pool is created by assigning an IPv6 Link Prefix (a subnet with a
length of /64) to an DHCPv6 option set. The definition of a separate set of IP ad-
dresses like, e.g. fc00:1:2:3::1..fc00:1:2:3::100, is - in contrast with IPv4 - not specified
for IPv6.
The following requirements must be met for the configuration of an IPV6 address pool:
(a) IPv6 has to be activated for the respective interface.
(b) An IPv6 Link Prefix (subnet) with a length of /64 has to be configured for the respective
interface. An IPv6 link prefix can be defined in either of two ways:
The IPv6 Link Prefix is derived from a General IPv6 Prefix (a prefix with a length of,
e.g., /56 or /48). In this case, the General IPv6 Prefix has to be configured in the
menu Networking->IPv6 General Prefixes->General Prefix Configuration .
The IPv6 Link Prefix with a length of /64 is manually configured for the respective in-
terface and is not derived from a General IPv6 Prefix.
(c) The DHCP Server option has to be enabled for the interface.
Moreover, the following settings are recommended:
The options Preferred Lifetime and Valid Lifetime should be set to values higher than
the value configured for the option Router Lifetime.
With a Router Lifetime of 600 seconds a Preferred Lifetime of, e.g., 900 seconds and a
Valid Lifetime of 1800 seconds are reasonable settings.
The option DHCP Mode should be enabled.
In order to make the settings mentioned above, go to the menu LAN->IP
Configuration->Interfaces. Choose the intended interface with the icon. Activate IPv6
and set the IPv6 Mode to A * A 3!. In the field
IPv6-Adressen, click Hinzufügen and configure the Link Prefix. Confirm your configuration
with Accept. The configuration of the recommended settings s then carried out in the fol-
lowing menus:
Router Lifetime: LAN->IP Configuration->Interfaces->New->Advanced
Settings->Advanced IPv6 Settings
Preferred Lifetime and Valid Lifetime: LAN->IP
Configuration->Interfaces->New->Basic IPv6 Parameters->Add->Advanced
bintec elmeg GmbH
17 Local Services
bintec RS Series 469

Table of Contents

Related product manuals