28
Before Getting Started
29
Before Getting Started
It is important to charge the transmitter battery to its full charge every time before you begin with
a new sensor to ensure data is collected from the sensor and sent to receiver during entire wear
period (14 days).
1. Take out your transmitter charger from its storage vial. Hold the
charger face up.
2. Make sure the alignment notch of the transmitter is facing the
charger’s transmitter compartment with transmitter metal
components facing down. With the transmitter outer frame between
your fingers, steadily slide the transmitter all the way into the
compartment.
1
2
Storage Vial
Transmitter Charger
Alignment
Notch
3. With the transmitter secured inside its charger compartment, turn
over the charger to the back side and slide the lock button
outwards.
4. Plug the charger’s USB plug into the USB port on the AC power
adapter supplied with the RIGHTEST CGMs, then plug the AC power
adapter inot the AC mains outlet (100 to 240V AC, 50/60 Hz).
3
Lock
Button
(in lock position)
4
To Next Page
Loading...
