3130
Before Getting Started
5
7
5. When you connect the transmitter charger to a USB power source, the LED
on the charger lights up. The charge condition of transmitter battery is
indicated below:
a solid green ( ) light means the battery is fully charged.
a solid amber ( ) light means the battery is charging.
6. After the transmitter is fully charged, unplug the transmitter charger from the power source.
7. If you wish to take out the transmitter from its charger, or to store the
transmitter charger, turn over the charger to the back side and press the
lock button slightly downward, then slide the lock button all the way inward.
NOTE :
If the LED doesn’t light up, make sure you connect to a power source with output rating of
500 mA or higher. If this does not solve the issue, check with another power source again then
contact customer support.
Fully charged
Charging
To Next Page
Loading...
